![]() |
SCADboard running in OpenSCAD |
First project made with SCADboard is SCADuino, hopefully many more will fallow and library will grow in functionality.
Basically, you can 3d print a board where you can attach all the components needed to get functioning Arduino.
You will also need:
- (1) Atmega328P with Arduino bootloader
- (1) 7805 5V Voltage regulator
- (2) LEDs
- (2) 220 Ohm resistors
- (1) 10k Ohm resistor
- (2) 10 uF capacitors
- (1)16 MHz clock crystal
- (2) 22 pF capacitors
- (1) Momentary normally open (“off”) button
- Red and Black 22 AWG wire
![]() |
Red surface board is printed with holes to fit the elements which are then connected with wires |
All the STL files, guide and code to make it and run it can be found at:
http://scaduino.wordpress.com/